VIII.  Centering Stock for Turning

There are several devices for sale which are supposed to help you find the center of a piece of stock that you want to turn in your wood lathe. And they work just fine, as long as the stock is round or square.

But usually the piece I want to turn is NOT square or round. It is likely to be almost any shape. Like the piece shown below.
 

So how do I find then center of irregularly shaped stock?

I use a pair of dividers.

I set the dividers to an approximate size and put one leg on the approximate center.

Then swing the divider to another side. Then check all 4 sides and adjust the divider until you have found the largest circle you can draw. Push the divider leg into the wood to mark the center.

Now draw the circle. I do this on both ends of the piece. If there is a defect or damage to the wood I can often move the center on one end to avoid it, particularly on a handle where one end is going to be small anyway.

Now I double check to make sure the stock is big enough for its intended use.

I use a center drill on the tailstock end where I normally use a live center. (A live center is one which has bearings inside and spins with the stock. A dead center does not turn. )

On the drive end of the wood the mounting method depends on how I intend to drive the piece, but I always have to have at least a small, shallow hole drilled for reference.

I bought and made several different devices for this, but in the end I found that my trusty dividers are easier and more certain than any other method.

As always, your mileage may vary.
 

January, 2006

The articles presented here are protected by applicable  Copyright Laws.
Copyright © 2005 James Thompson.  All Rights Reserved.