 |
|
|
In the Shop
I was looking for a plane to clean but it seems I had already cleaned all of mine. Umm time to go hunting again. Anyway, this was the only dirty tool I had around. It is an unnamed mortise gauge that is completely unremarkable. It came from a yard sale with four others for a $1.75. The principals are the same, no matter what the tool is.
Step one:Disassemble completely. This allows you get all of the junk off and out from wherever it is.
Step Two:Using a quality mechanics hand cleaner without pumice, clean well. I prefer GOJO with lanoline, or wool fat. If I want to just remove the accumulated gunk and wish to preserve as much ‘patina’ as possible, I use only my hands to rub it in. In this case I wanted to get it bright so I used 0000 steel wool to scrub in the cleaner. Rub with the grain. Remember to rinse well with clean water.
Step Three:Raising the figure with BLO. The only tricky part and I don’t even know if its necessary. I use 1 part Boiled Linseed oil mixed with 2 parts Mineral spirits. I always make sure that this is a least warm. Be very careful heating it, it is flammable. I use a microwave. I cant say if it make a difference being hot but it seems to thin out very nicely and is absorbed quicker. I applied this mix with a paper towel folded four times. Wipe off as much as possible after ten minutes or so. If this was a heavily figured piece of wood I would have done this several time over the course of a few days. As I was in a rush I only did one coat.
Step Four:Waxing
The last two steps are the same I used for putting a finish on this Stair/ Dado saw I made. It is from a scrap piece of decking I picked up at work.
Ray
Drake Bio Note:
Occupation: Project manager residential construction in NYC.
I started in remodeling @ 19 and spent the last 15 years doing
high end trim work. I also have photos of my shop and a
few projects such as Making a bow saw, frame saw, stair saw,
chute boards, four squaring a board to size from rough sawn
stock etc. |
|||||
|
|
 |
